HealthWavy Smart Health Tools for Everyday Wellness

Everyday Wellness · Electrolyte accounting

Sweat Sodium Loss Calculator

Estimate sodium loss from sweat volume and a supplied sweat-sodium concentration, with duration scenarios and sodium-to-salt equivalents.

MODEL WORKSPACE

Electrolyte accounting workspace

Measured concentration; no replacement target

Example values are shown. Change them to calculate your result.

YOUR RESULT

Your electrolyte loss worksheet

1,200 mg · estimated sodium loss

NaCl-equivalent mass: 3.050 g (not a replacement target)

Estimated sweat volume1.5 L
Entered sodium concentration800 mg/L
Sodium loss rate800 mg/hour
NaCl mass equivalent3.0504 g
Full result table
Calculated from the current values, with rounded display.
Duration minSweat LSodium mg
300.5400
601800
901.51,200
901.51,200
12021,600

Both sweat rate and concentration can vary with conditions and measurement methods. NaCl equivalent is a chemical conversion, not a replacement or supplement recommendation. No safe drinking volume or sodium dose is calculated.

HEALTHWAVY AI

Let’s work it out.

Ask about this tool, enter your values, or understand your result.

Ask in your own language.

GET STARTED

How to use Sweat Sodium Loss Calculator

  1. Enter sweat rate in litres per hour and sodium concentration in milligrams per litre.
  2. The volume calculation assumes your chosen sweat rate remains constant for the entered exercise time.
  3. The table extends the same rate across duration scenarios and converts sodium mass to a sodium-chloride equivalent.

Worked example

1 L/hour for 90 minutes gives 1.5 L sweat. At 800 mg/L that contains an estimated 1,200 mg sodium; the sodium chloride equivalent is shown separately.

Formula, accuracy & limitations

Sweat volume = rate × duration(hours). Sodium loss(mg) = volume(L) × sodium concentration(mg/L). NaCl-equivalent grams = sodium mg/1000 × 58.44/22.98976928.

Both sweat rate and concentration can vary with conditions and measurement methods. NaCl equivalent is a chemical conversion, not a replacement or supplement recommendation. No safe drinking volume or sodium dose is calculated.

These outputs use the stated model and your supplied inputs. A mathematically consistent model can still differ from personal measurements. Scenario curves and formula comparisons are not statistical confidence intervals.

Source and method context ↗

Use sodium rather than total salt concentration

Enter sweat rate in litres per hour and sodium concentration in milligrams per litre. A lab or device report may express concentration in mmol/L; that must be converted using sodium’s molar mass before entry. Total salt and sodium are not the same mass quantity.

Match the duration and conditions

The volume calculation assumes your chosen sweat rate remains constant for the entered exercise time. Heat, clothing, acclimation and intensity can change sweating. A reading from one session should not automatically be treated as a fixed personal value for every environment.

Separate loss accounting from replacement

The table extends the same rate across duration scenarios and converts sodium mass to a sodium-chloride equivalent. It does not tell you to replace every milligram or prescribe fluid. Intake choices depend on additional factors that are not supplied to this accounting tool.

Keep the sodium and salt units separate

A 1.5-litre sweat volume at 800 mg sodium per litre contains 1,200 mg sodium under the constant-concentration assumption. Sodium chloride contains sodium plus chloride, so its equivalent mass is larger. The conversion uses the molar-mass ratio 58.44/22.98976928 rather than treating one gram of sodium as one gram of salt. A regional sweat patch can also differ from a whole-body estimate. Confirm what the measurement represents before multiplying it across an entire session.

QUICK ANSWERS

Frequently asked questions

Can I use the existing sweat-rate calculator first?

That tool can provide a sweat-rate estimate from mass and fluid measurements. You still need a separate sodium-concentration input for this calculation.

Is the salt equivalent a supplement target?

It is only a chemical mass conversion. The output does not recommend consuming that amount of salt.

What if my concentration is in mmol/L?

Multiply sodium mmol/L by 22.98976928 to obtain mg/L before entry. Confirm the report refers to sodium rather than a different electrolyte.

Is concentration constant during a long event?

The model holds it constant for the scenario. Real concentration and sweat rate can change, so the output remains an estimate.