HealthWavy Smart Health Tools for Everyday Wellness

Body & Fitness · Respiratory gas analysis

Indirect Calorimetry Calculator

Calculate RER and Weir energy expenditure from measured respiratory gases, with non-protein substrate estimates under stated assumptions.

MODEL WORKSPACE

Respiratory gas analysis workspace

Measured steady-state gas inputs only

Example values are shown. Change them to calculate your result.

YOUR RESULT

Your respiratory gas worksheet

0.8 RER · measured-gas ratio

Weir rate: 1.4477 kcal/min

Energy rate1.44774 kcal/min
Entered-interval energy28.9548 kcal
24-hour constant-rate extrapolation2,084.7456 kcal
Carbohydrate oxidation0.129 g/min
Fat oxidation0.1002 g/min
Full result table
Calculated from the current values, with rounded display.
Constant-rate minutesEnergy kcalCarbohydrate gFat g
11.447740.1290.1002
2028.95482.582.004
6086.86447.746.012

Requires reliable steady-state measured gas exchange. Restricted to RER 0.71–1.00 for the non-negative non-protein estimates used here. Protein oxidation, nitrogen correction and non-steady-state gas dynamics are omitted. A daily extrapolation is a constant-rate scenario, not measured daily expenditure.

HEALTHWAVY AI

Let’s work it out.

Ask about this tool, enter your values, or understand your result.

Ask in your own language.

GET STARTED

How to use Indirect Calorimetry Calculator

  1. Enter oxygen uptake and carbon-dioxide production measured on the same basis in litres per minute.
  2. The supported ratio keeps the simplified non-protein carbohydrate and fat equations non-negative.
  3. The interval total multiplies the computed rate by your entered duration.

Worked example

VO₂ 0.30 and VCO₂ 0.24 L/min give RER 0.80, Weir energy 1.44774 kcal/min, carbohydrate 0.129 g/min and fat 0.1002 g/min.

Formula, accuracy & limitations

RER = VCO₂/VO₂. Abbreviated Weir energy = 3.941 VO₂ + 1.106 VCO₂ kcal/min. Non-protein Frayn estimates: carbohydrate = 4.55 VCO₂ − 3.21 VO₂ g/min; fat = 1.67(VO₂ − VCO₂) g/min. Gas volumes are L/min.

Requires reliable steady-state measured gas exchange. Restricted to RER 0.71–1.00 for the non-negative non-protein estimates used here. Protein oxidation, nitrogen correction and non-steady-state gas dynamics are omitted. A daily extrapolation is a constant-rate scenario, not measured daily expenditure.

These outputs use the stated model and your supplied inputs. A mathematically consistent model can still differ from personal measurements. Scenario curves and formula comparisons are not statistical confidence intervals.

Source and method context ↗

Original Weir energy-expenditure method ↗

Use measured gases rather than wearable guesses

Enter oxygen uptake and carbon-dioxide production measured on the same basis in litres per minute. Millilitres must be divided by 1,000 first. This page cannot infer respiratory gases from heart rate, exercise speed or the VO₂ max estimate on another tool.

Inspect RER before interpreting substrates

The supported ratio keeps the simplified non-protein carbohydrate and fat equations non-negative. Measurements outside that interval can be real under other conditions, but those conditions need a different interpretation. The engine rejects them rather than silently clamping substrate use to zero.

Separate the measured interval from extrapolation

The interval total multiplies the computed rate by your entered duration. A 24-hour figure assumes that same gas exchange rate persists all day. It is labelled an extrapolation and should not be treated as an independently measured resting or daily energy requirement.

Audit gases, rates and totals in their own units

For VO₂ 0.30 and VCO₂ 0.24 L/min, the ratio is 0.80 and the energy rate is 1.44774 kcal/min. Over the entered 20-minute interval, the constant-rate total is 28.9548 kcal. The non-protein equations give carbohydrate 0.129 g/min and fat 0.1002 g/min, which are mass rates rather than energy percentages. Adding those gram values to calories, or dividing by a 24-hour total, would mix incompatible units. Keep the measured interval and the extrapolated day distinct.

QUICK ANSWERS

Frequently asked questions

Can I enter VO₂ max here?

The input is current measured oxygen consumption paired with simultaneous carbon-dioxide production. A maximum capacity estimate is not that measurement.

Why can carbohydrate and fat energy not exactly match Weir?

The displayed substrate equations and energy equation use different simplifying constants and omit protein. They are reported in their own units without forcing a false reconciliation.

Why reject RER above one?

The non-protein oxidation interpretation used here is not suitable for that measurement range. The rejection describes model scope, not whether the person or device is healthy.

Is the 24-hour number a recommended intake?

It is a constant-rate extrapolation only. It does not include a measured full day, a diet target or an activity multiplier.